add doc/check-health.md

doc/check-health.md

@@ -0,0 +1,43 @@
+Notify about health state
+=========================
+
+[◀ Go back to main README](../README.md)
+
+Description
+-----------
+
+This script is run from scheduler periodically, sending notification on
+health related events:
+
+* voltage jumps up or down more than configured threshold
+* power supply failed or recovered
+* temperature is above or below threshold
+
+Note that bad initial state will not trigger an event.
+
+Only sensors available in hardware can be checked. See what your
+hardware supports:
+
+    / system health print;
+
+Requirements and installation
+-----------------------------
+
+Just install the script and create a scheduler:
+
+    $ScriptInstallUpdate check-health;
+    / system scheduler add interval=1m name=check-health on-event="/ system script run check-health;" start-time=startup;
+
+Configuration
+-------------
+
+The configuration goes to `global-config-overlay`, These are the parameters:
+
+* `CheckHealthTemperature`: an array specifying temperature thresholds for sensors
+* `CheckHealthVoltagePercent`: percentage value to trigger voltage jumps
+
+Also notification settings are required for e-mail and telegram.
+
+---
+[◀ Go back to main README](../README.md)  
+[▲ Go back to top](#top)