diff --git a/README.md b/README.md
index 9d0ea4a..9f062a9 100644
--- a/README.md
+++ b/README.md
@@ -28,7 +28,7 @@ The build script uses [Docker Buildx](https://docs.docker.com/buildx/working-wit
 
 ### Configure the Router
 
-The router must be be running RouterOS v7.4rc2 or later with the container package loaded; this section follows the Mikrotik Container documentation with additional steps to route the LAN subnet via the tailscale container.
+The router must be be running RouterOS v7.5beta4 or later with the container package loaded; this section follows the Mikrotik Container documentation with additional steps to route the LAN subnet via the tailscale container.
 
 1. Upload the `tailscale.tar` file to your router. Below we will assume the image is located at `disk1/tailscale.tar`
 
@@ -52,10 +52,10 @@ The router must be be running RouterOS v7.4rc2 or later with the container packa
 /interface/bridge/port add bridge=dockers interface=veth1
 ```
 
-5. Setup NAT for outgoing WAN traffic. 
+5. Enable routing from the LAN to the Tailscale Network 
 
 ```
-/ip/firewall/nat/add chain=srcnat action=masquerade src-address=172.17.0.0/16 out-interface=ether1
+/ip/route/add dst-address=100.64.0.0/10 gateway=172.17.0.2
 ```
 
 6. Create environment variables as per the list below.
diff --git a/tailscale.sh b/tailscale.sh
index bbe2493..8d4c16d 100755
--- a/tailscale.sh
+++ b/tailscale.sh
@@ -14,7 +14,7 @@ for s in "${SUBNETS[@]}"; do
 done
 
 # Start tailscaled and bring tailscale up 
-/usr/local/bin/tailscaled --tun=userspace-networking &
+/usr/local/bin/tailscaled &
 until /usr/local/bin/tailscale up \
 	--authkey=${AUTH_KEY} \
 	--advertise-routes="${ADVERTISE_ROUTES}"